Acura NSX 1997 Service Manual page 303

Main Menu
Transmission Assembly
Removal (cont'd)
19. Remove the intermediate shaft heat cover and the intermediate shaft mounting bolts.
20. Pry the intermediate shaft out of the differential. Pull and remove it. Coat all precision finished surfaces with clean
engine oil or grease. Tie plastic bags over the driveshaft ends.
21. Remove the parking brake cable holder from the rear sub frame, and the wheel sensor wire clamp from the lower
control arm.
22. Remove the flange bolt, and separate the toe control arm from the side beam (see
23. Remove the damper fork bolt (see
24. Remove the adjusting bolts, and the flange bolt, then separate the lower control arm from the side beam.
25. Pry the driveshaft out of the differential. Pull and remove it. Coat all precision finished surfaces with clean engine oil
or grease. Tie plastic bags over the driveshaft ends.
Table of Contents
section 18).
section 18).