Acura NSX 1997 Service Manual page 612

Main Menu
Remove the flat head screws. Install two 8 x 12 mm
bolts into the disc to push it away from the hub.
NOTE: Turn each bolt two turns at a time to pre-
vent cocking the disc excessively.
BRAKE DISC
9. Remove the rear hub unit from the knuckle.
FLANGE BOLT
10 x 1.25 mm
64 N-m (6.5 kgf-m, 47 Ibf-ft)
Corrosion resistant bolt/nut
Table of Contents
FLAT HEAD SCREW
6 x 1.0 mm
9.8 N-m (1.0 kgf-m, 7 Ibf-ft)
8 x 12 mm
BOLT
REAR HUB UNIT
Rear Wheel Bearing Replacement:
1. Separate the wheel bearing from the hub using the
special tools and a press.
CAUTION: Hold onto the hub to keep it from fall-
ing when pressed clear.
Press
HUB DIS/ASSEMBLY
BASE
07GAF - SD40700
2. Remove the wheel bearing inner race from the hub
using the special tool and a press.
Press
NOTE: Wash the bearing and hub thoroughly in
high flash point solvent before reassembly.
HUB DIS/ASSEMBLY PIN
07GAF - SD40100
WHEEL BEARING
Replace.
HUB
HUB DIS/ASSEMBLY PIN
07GAF - SD40100
INNER RACE
Replace.
BEARING
SEPARATOR
0-4
(Commercially
available)
(cont'd)