Acura NSX 1997 Service Manual page 791

Table of Contents

Roof Side Seal/Retainer Replacement (cont'd)

9. If the old roof side retainer is to be reinstalled, glue

the new EPT sealer to it as shown.

NOTE: Be careful not to touch the roof side retainer

where the EPT sealer will be applied.

Length: 15 mm (0.59 in)

Width: 25 mm (0.98 in)

Thickness: 5 mm (0.2 in)

Length: 75 mm (3.0 in)

Width: 10 mm (0.39 in)

Thickness: 3 mm (0.1 in)

10. If the old roof side seal is to be reinstalled, scrape

the old butyl tape from each end of it, then clean

each end with alcohol. Glue the new butyl tape on

each end as shown.

Butyl tape thickness: 0.5 mm (0.02 in)

(Rear portion)

Table of Contents

Length: 445 mm (17.5 in)

Width: 10 mm (0.39 in)

Thickness: 10 mm (0.39 in)

(Front portion)

11. Install the roof side retainer.

• Be careful not to touch the roof side retainer

where sealant will be applied.

• Align each end of the roof side retainer with the

roof corner edges.

Screw locations, 3

12. Glue the new EPT sealer on the roof as shown.

EPT sealer thickness: 3.0 mm (0.12 in)

Chapters

Table of Contents