Acura NSX 1997 Service Manual page 1032

Main Menu
Replacement
SRS components are located in this area. Review the
SRS component locations, precautions, and procedures
in the SRS section 24 before performing repairs or ser-
vice.
1. Remove the clock (see page 23-233).
2. Remove the two screws behind the clock, then
remove the center air vent (see
3. Remove the four screws, then remove the center
armrest.
4. Take out the ashtray.
5. Remove the five screws and center console panel,
then disconnect the 3P connector and 4P connector
from the floor wire harness.
ASHTRAY
CENTER
CONSOLE
PANEL
CENTER ARMREST
Table of Contents
section 20).
CENTER AIR VENT
4P CONNECTOR
3P CONNECTOR
6. Disconnect the thermo fuse case from the end of
the cigarette lighter socket.
7. Remove the ring nut, and separate the cigarette
lighter socket from the thermal protector.
8. When installing the cigarette lighter, align each lug
on the face panel, illumination ring and cigarette
lighter socket with the groove in the hole, then posi-
tion the bulb housing on the thermal protector
between the stops on the center console panel.
9. Make sure that the ground, bulb socket and thermo
fuse case are seated against the cigarette lighter
assembly.
CIGARETTE
LIGHTER
SOCKET
ILLUMINATION
RING
RING NUT
THERMO FUSE CASE
CIGARETTE LIGHTER
LIGHT (1.4 W)
CENTER CONSOLE
ASHTRAY LIGHT (1.4 W)
PANEL
FACE PANEL
THERMAL
PROTECTOR
GROUND
WIRE