Acura NSX 1997 Service Manual page 257

Main Menu
(From page 11-144)
Check for an open in the wire
(IGSW line):
Measure voltage between the
PGM-FI main relay 4P connector
terminal No. 4 and body ground.
Is there battery voltage?
Check for an open or short in the
wire (STS line):
1. Turn the ignition switch to the
START (III) position.
NOTE:
• M/T: Clutch pedal must be
depressed.
• A/T: Transmission in
position.
2. Measure the voltage between
the PGM-FI main relay 8P con-
nector terminal No. 3 and
body ground.
Is there battery voltage?
Check for an open in the wire
(FLR1 line):
1. Turn the ignition switch OFF.
2. Disconnect the ECM connec-
tor A (26P) from the ECM.
3. Check for continuity between
the PGM-FI main relay 8P
connector terminal No. 2 and
ECM connector terminal A4.
Is there continuity?
(To page 11-146)
Table of Contents
Replace the IG COIL (30 A)
fuse in the engine compart-
ment fuse/relay box.
Repair open or short in the
wire between the PGM-FI
main relay and the IG COIL
(30 A) fuse.
or
Replace the No. 7 STARTER
SIGNAL (7.5 A) fuse in the
under-dash fuse box.
Repair open or short in the
wire between the PGM-FI
main relay and the No. 7
STARTER SIGNAL (7.5 A) fuse.
Repair open in the wire between
the ECM (A4) and the PGM-FI
main relay.
(cont'd)