Acura NSX 1997 Service Manual page 742

Table of Contents

Rear Hatch Glass

Installation (cont'd)

11. Scrape or wipe the excess adhesive off with a put-

ty knife or towel.

NOTE: Use a soft shop towel dampened with

alcohol to remove adhesive from a painted surface

1 2. After the adhesive is dry, spray water over the

glass and check for leaks. Mark leaking areas and

let the glass dry, then seal with sealant.

NOTE: Let the car stand for at least four hours

after glass installation. If the car has to be used

within the first four hours, it must be driven slowly.

13. Remove the spacers.

14. Install the support struts.

Table of Contents

Chapters

Table of Contents