Acura NSX 1997 Service Manual page 873

Table of Contents

Remove the snap ring A and the field coil.

• Be careful not to damage the field coil and com-

pressor during removal/installation.

• Once the snap ring A was removed, replace it

with a new one.

Install parts in the reverse order of removal, and:

• Install the field coil with the wire side facing

down (see above).

• Clean the pulley and compressor sliding surfaces

with non-petroleum solvent.

• Check the pulley bearings for excessive play.

• Make sure the snap rings are in the groove

• Apply locking agent to the threads on the center

• Make sure that the pulley turns smoothly after it's

reassembled.

Table of Contents

Chapters

Table of Contents