Acura NSX 1997 Service Manual page 746

Main Menu
Seats
Replacement
NOTE:
• Before removing the seat, move the seat until you
can see its mounting bolts and seat mount cover
caps.
• Take care not to scratch the seat cover, interior trim,
dashboard and center armrest.
• On reassembly, replace the lower anchor bolt ( * ) and
use liquid thread lock.
1. Pry out the seat mount cover caps.
2. Remove the seat mounting bolts, then remove the
seat and disconnect the connector.
3. Pry out the cap, and remove the seat belt lower
anchor bolt. Remove the seat.
SEAT MOUNTING BOLTS
10 x 1.25 mm
39 N-m (4.0 kgf-m, 29 Ibf-ft)
CONNECTOR
If necessary, remove the power slide cable, power
seat switch and seat mount cover.
POWER SLIDE CABLE
NOTE: Take care not to
bend the cable.
4. Installation is the reverse of the removal procedure.
NOTE: Apply grease to the inner and outer slide
box gears.
Table of Contents
INNER SLIDE
BOX GEAR
SEAT MOUNT
COVER CAP
OUTER SLIDE
BOX GEAR
POWER SEAT
SWITCH
Disconnect the connectors.
SEAT
SEAT MOUNTING
BOLTS
10 x 1.25 mm
39 N-m (4.0 kgf-m,
29 Ibf-ft)
SEAT BELT
LOWER ANCHOR
BOLT
7/16-20 UNF
32 N-m (3.3 kgf-m,
24 Ibf-ft)
CAP
CORROSION RESISTANT BOLT
CLIP
Pry here.
HOOK
Pry here.
SEAT MOUNT COVER