Acura NSX 1997 Service Manual page 647

Main Menu Table of Contents
Rear Brake Disc
Run-Out Inspection
1. Raise each side of the vehicle, and support it on
safety stands (see page
rear wheels.
2. Remove the brake pads (see page 19-18).
3. Inspect the disc surface for grooves, cracks, and
rust. Clean the disc thoroughly and remove all rust.
4. Use the wheel nuts and plain washers to hold the
disc securely against the hub, then mount a dial
indicator as shown.
Brake Disc Runout:
Service Limit: 0.10 mm (0.004 in)
5. If the disc is beyond the service limit, refinish the
rotor.
Max. Refinishing Limit: 21.0 mm (0.83 in)
NOTE: A new disc should be refinished if its runout
is greater than 0.1 mm (0.004 in).
1-10 through 1-12). Remove the