Starter Reassembly - Acura NSX 1997 Service Manual

Main Menu
Overrunning Clutch Inspection
1. Check if the overrunning clutch moves along the
shaft freely. If not, replace the overrunning clutch
assembly.
2. Check if the overrunning clutch locks in one direc-
tion and rotates smoothly in reverse. If it does not
lock in either direction or it locks in both directions,
replace the overrunning clutch assembly.
3. Check if the starter drive gear is worn or damaged.
If the gear is worn or damaged, replace the over-
running clutch assembly; the gear is not available
separately.
NOTE: Check the condition of the flywheel or tor-
que converter ring gear if the starter drive gear
teeth are damaged.
Table of Contents

Starter Reassembly

Reassemble the starter in the reverse order of
disassembly.
1. Pry back each brush spring with a screwdriver,
then position the brush about halfway out of its
holder, and release the spring to hold it there.
2. Install the armature in the housing. Next pry back
each brush spring again, and push the brush down
until it seats against the commutator. Then release
the spring against the end of the brush.
3. Install the end cover on the brush holder.
BRUSH HOLDER
END COVER
O-RING