Engine Cover/Roof Cover Removal - Acura NSX 1997 Service Manual

Main Menu
Engine Cover/Roof Cover
Removal
NOTE:
• Take care not to scratch the body.
• Open the rear hatch.
1. Open the engine cover, and support it with the sup-
port rod. Disconnect the roof holder switch connec-
tor, remove the nut, then remove the ground wire.
NOTE: If necessary, remove the roof switch sub-
harness.
ROOF HOLDER
SWITCH
NUT
GROUND
CONNECTOR
WIRE
Table of Contents
ENGINE COVER
SUPPORT
ROD
GROMMET
HARNESS
CLIP
Detach it.
CONNECTOR
ROOF HOLDER SWITCH
SUB-HARNESS
2. Remove the support rod from the engine cover.
Remove the bolts, than remove the engine cover.
Bolt locations, 4
ENGINE COVER
EDGE CUSHIONS
ENGINE COVER
HINGE
3. Installation is the reverse of the removal procedure.
NOTE:
• Make sure the roof holder switch connector is
connected properly.
• If necessary, turn the engine cover edge cush-
ions to make the engine cover fit flush with the
body.
ENGINE COVER
ENGINE COVER
EDGE CUSHIONS
CORROSION RESISTANT BOLT