Acura NSX 1997 Service Manual page 1139

Table of Contents

Airbag Assembly Installation

• Be sure to install the SRS wiring so that it is not pin-

ched or interfering with other car parts.

• Be sure the battery cables are disconnected.

• After completing repair work, be sure to remove the

short connectors (RED) and reconnect all the con-

Driver's Airbag:

Place the driver's airbag assembly in the steering

wheel, and secure it with new Torx bolts.

9.8 N-m (1.0 kgf-m, 7.2 Ibf-ft)

Use a Torx T30 bit

Table of Contents

9.8 N-m (1.0 kgf-m,

7.2 Ibf-ft) Replace.

Use a Torx T30 bit

AIRBAG ASSEMBLY

Passenger's Airbag:

Place the passenger's airbag assembly in the

Press the airbag assembly downwards, and turn the

adjusting nut until it touches the lower part of the

airbag assembly. Then, turn it back half a turn so

that there is a small gap between adjusting nut and

the airbag assembly.

Install the bracket and mounting nuts.

Tighten the three airbag mounting nuts, then

tighten the two mounting nuts on the bracket.

AIRBAG ASSEMBLY

MOUNTING NUTS

9.8 N-m (1.0 kgf-m, 7.2 Ibf-ft)

9.8 N-m (1.0 kgf-m, 7.2 Ibf-ft)

Chapters

Table of Contents