Table of Contents
Advertisement
Main Menu
Key-in Reminder System
Ignition Key Switch Test
NOTE: Refer to page
23-167
key -in reminder beeper circuit.
When the ignition key is not removed, the key-in
reminder in the integrated control unit senses ground
through the closed ignition key switch. When you open
the driver's door, the reminder circuit senses ground
through the closed door switch. With ground at the
"BLU/GRN" and "GRN/BLU
sounds.
1.
Remove the dashboard lower cover, and disconnect
the floor wire harness connectors.
Table of Contents
for the input test of the
2
" terminals, the beeper
DASHBOARD
LOWER
COVER
3.
Disconnect the 8P connector from the floor wire
harness.
4.
There should be continuity between the No. 8 and
No. 7 terminals when the ignition key is inserted.
There should be no continuity with the ignition key
removed.
View from wire side
Advertisement
Chapters
Table of Contents
Troubleshooting
