Acura NSX 1997 Service Manual page 595

Main Menu
Front Suspension
Hub Replacement
1. Loosen the wheel nuts slightly.
2. Raise the front of vehicle, and support it on safety
stands in proper locations (see
3. Remove the wheel nuts and wheel.
NOTE: Before installing the wheel,
mating surfaces of the brake disc and inside of the
wheel.
4. Remove the brake hose mounting bolts.
BRAKE HOSE MOUNTING BOLTS
22 N-m (2.2 kgf-m, 16 Ibf-ft)
Corrosion resistant bolt/nut
Table of Contents
section 1).
clean the
WHEEL NUT
108 N-m
(11 kgf-m, 80 Ibf-ft)
FRONT BRAKE HOSE
5. Remove the wheel sensor from the knuckle and
front lower control arm.
NOTE:
• Do not disconnect the wheel sensor.
• Be careful when installing the sensors to avoid
twisting wires.
WHEEL
SENSOR
Corrosion resistant bolt/nut
6. Remove the caliper bracket mounting bolts, and
hang the caliper assembly to one side.
CAUTION: To prevent accidental damage to the
caliper assembly or brake hose, use a short piece of
wire to hang the caliper assembly from the
undercarriage.
CALIPER BRACKET MOUNTING BOLTS
108 N-m (11 kgf-m, 80 Ibf-ft)
9.8 N-m
(1.0 kgf-m, 7 Ibf-ft)
Corrosion resistant bolt/nut
9.8 N-m
(1.0 kgf-m, 7 Ibf-ft)
22 N-m
(2.2 kgf-m, 16 Ibf-ft)