Main Menu
Synchro Sleeve, Synchro Hub
Inspection
1.
Inspect gear teeth on all synchro hubs and synchro
sleeves for rounded off corners, which indicates
wear.
2.
Install each synchro hub in its mating synchro
sleeve, and check for freedom of movement.
If replacement is required, always replace the syn-
chro sleeve and synchro hub as a set.
Table of Contents
Each synchro sleeve has three sets of longer teeth (120
degrees apart) that must be matched with the three
sets of deeper grooves in the synchro hub when
assembled.
Installing the synchro sleeve with its longer teeth in the
synchro hub slots will damage the spring ring.
Installation