Acura NSX 1997 Service Manual page 744

Table of Contents

Scrape all traces of the old molding from the cham-

fered edges of the glass.

NOTE: Be sure to scrape all traces of the old mold-

ing throughly.

Scrape here.

Clean the glass surface with alcohol where the new

molding is to be installed.

NOTE: Make sure the surface is kept free of water,

oil and grease.

With a brush, apply a light coat of glass primer

around the edge of the glass.

INSIDE SURFACE

NOTE: Scrape off excess glass primer with a putty

knife after installing the new molding.

Degrease the inner surfaces of the new molding

thoroughly, then apply a light coat of glass primer

to the surfaces.

• Apply glass primer around the entire groove of

the new molding.

• Do not apply glass primer to the outer surface.

Run a bead of adhesive in the groove of the

Table of Contents

EXCESS PRIMER

10. Press the molding into position around the entire

edge of the glass.

NOTE: Check that the molding is not wrinkled or

lifted away at the corners.

11. Scrape or wipe the excess adhesive off with a put-

ty knife or towel.

NOTE: Use a soft shop towel dampened with

alcohol to remove adhesive from a painted surface

(Glass Surface)

EXCESS ADHESIVE

Surface to be

wiped clean.

Chapters

Table of Contents