Acura NSX 1997 Service Manual page 721

Table of Contents

Adjust the clearance "B" as follows:

NOTE: Raise the glass fully.

a. Lower the glass 10 mm (0.4 in)

b. Push the glass outward 10 mm (0.4 in), then push

the inside stabilizers against the glass lightly.

Retighten the mounting bolts securely.

NOTE: Check that the glass moves smoothly.

c. Raise the glass fully.

d. Loosen the locknuts, and turn the adjusting bolts

until the clearance "B" is within the specified

Table of Contents

(See page 20-15)

NOTE: Turn the front and rear adjusting bolts the

same amount so as to keep the glass guide brack-

et parallel with the seating surface of the door.

After tightening the adjusting bolts, make sure

that the ends of the adjusting bolts still project

out of the locknuts.

e. Align the front sash and rear sash with the glass

with the adjusting bolts at the bottom of the

f. Move the glass up and down to seat it, then

measure the clearance "B" at the designated

locations (see page 20-15).

g. Again measure the clearance "H" to make sure

it is still within the specified limit at the designat-

ed locations.

NOTE: Repeat the above steps until the correct

clearances are obtained.

Chapters

Table of Contents