Acura NSX 1997 Service Manual page 576

Main Menu
Retighten the locknut while holding the rack
guide screw with a wrench.
LOCKNUT WRENCH, 40 mm
07916-SA50001
Table of Contents
Tie-rod installation:
5. Screw each rack end into the rack while holding the
lock washer so its tabs are in the slots in the rack
end.
NOTE: Install the stop washer with the chamfered
side facing out.
6. Tighten the rack end securely, then bend the lock
washer back against the flat on the flange as shown.