Acura NSX 1997 Service Manual page 1219

Main Menu
9. Pack adhesive into the cartridge without air pockets
to ensure continuous delivery. Put the cartridge in a
caulking gun, and run a bead of adhesive around
the edge of the rear window as shown.
NOTE: Apply the adhesive within thirty minutes
after applying the glass primer.
Make a slightly
thicker bead at
each corner.
Table of Contents
10. Use suction cups to hold the rear window over the
opening, align it with the alignment marks made in
step 4, and set it down on the adhesive. Lightly
push on the rear window until its edges are fully
seated on the adhesive all the way around.
NOTE: Do not close or open the doors until the
adhesive is dry.
11. After the adhesive is dry, spray water over the rear
window and check for leaks. Mark leaking areas and
let the rear window dry, then seal with sealant.
NOTE: Let the vehicle stand for at least four hours
after rear window installation. If the vehicle has to
be used within the first four hours, it must be driven
slowly.
12. Connect the rear defogger sub-harness and ground
cable/antenna lead, then install the grommets.
13. Reinstall all remaining removed parts.