Seat Belt Tensioner Removal - Acura NSX 1997 Service Manual

Table of Contents

Seat Belt Tensioner Removal

Do not install used SRS parts from another car: use

only new SRS parts.

Carefully inspect the seat belt tensioner before install-

ing it. Do not install a tensioner that shows signs of

being dropped or improperly handled, such as dents,

cracks or deformation.

The shoulder harness anchor bolt must be removed

before you remove the tensioner.

After completing repair work, be sure to remove SRS

Service Connector.

Before disconnecting any part of the SRS wire

harness, install the short connectors (RED) (see page

Remove the rear trim panel, upper trim panel, rear

side trim panel, and rear pillar trim panel.

T R I M PANEL

REAR SIDE TRIM

Table of Contents

Disconnect the 3P connector from the seat belt ten-

sioner, then install the short connectors (RED) on the

seat belt tensioners.

Remove the shoulder harness anchor bolt, then

remove the two seat belt tensioner mounting bolts

and tensioner.

FLOOR WIRE HARNESS

3P CONNECTOR

Table of Contents