Acura NSX 1997 Service Manual page 1297

Main Menu
Mainshaft Assembly
Index
NOTE: The 3rd/4th and 5th/6th synchro hubs are installed with a press.
Prior to reassembling, clean all the parts in solvent, dry them, and apply lubricant to any contact surfaces.
The 3rd/4th and 5th/6th synchro hubs, however, should be installed with a press before lubricating them.
Table of Contents
INNER SYNCHRO RING
SYNCHRO CONE
OUTER SYNCHRO RING
SYNCHRO SPRING
3RD/4TH SYNCHRO SLEEVE
3RD/4TH SYNCHRO HUB
SYNCHRO SPRING
OUTER SYNCHRO RING
SYNCHRO CONE
INNER SYNCHRO RING
3RD GEAR
42 x 47 x 30.5 mm
NEEDLE BEARINGS
Inspect for wear and operation.
MAINSHAFT
BALL BEARING
Inspect for wear and operation.
ANGULAR BALL BEARING
Check for wear and operation.
Note the direction of installation.
DISTANCE COLLAR
42 x 47 x 22 mm
NEEDLE BEARING
Inspect for wear and operation.
6TH GEAR
INNER SYNCHRO RING
SYNCHRO CONE
OUTER SYNCHRO RING
SYNCHRO SPRING
5TH/6TH SYNCHRO SLEEVE
5TH/6TH SYNCHRO HUB
SYNCHRO SPRING
OUTER SYNCHRO RING
SYNCHRO CONE
INNER SYNCHRO RING
5TH GEAR
42 x 47 x 26.5 mm
NEEDLE BEARING
Inspect for wear and operation.
SPACER COLLAR
42 x 47 x 26.5 mm
NEEDLE BEARING
Inspect for wear and operation.
4TH GEAR