Acura NSX 1997 Service Manual page 1299

Main Menu
Shift Lock Release Cover
Installation ——————————
Take the "SHIFT LOCK RELEASE" cover off the A/T
gear position indicator panel, and peel off the
remaining adhesive.
Clean the indicator panel thoroughly with a sponge
dampened in alcohol.
A/T GEAR POSITION
INDICATOR PANEL
2. Remove the peel-off backing from the new cover.
3. Install the cover by aligning the right end with the
hollow egde, and press the cover with your fingers
to secure it.
Make sure the new cover does not move or is not
taken off.
Table of Contents
SHIFT LOCK RELEASE
COVER
Peel off the
remaining
adhesive.
COVER
HOLLOW EDGE
KEYHOLE
4. Make sure the slot on the left end of the cover is
exposed. If the slot is covered, remove the cover
and reinstall it properly.
SLOT
COVER