Checking The Sheet Feeding Angle - Horizon Fitness AFC-566F Manual

4-3

Checking the Sheet Feeding Angle

Bring the sheet up to the stopper on
the first buckle chute using the Nor-
mal Jog button on the control panel.
-If the reverse side of the sheet is fed, bring the
sheet up to the second buckle stopper.
-When the sheet is very close to the buckle
stopper, feed the sheet using the handwheel.
When the sheet touches the first
buckle stopper, check that both cor-
ners of the sheet touch the buckle
stopper at the same time.
If the sheet is not trimmed correctly (not square),
adjust the angle of the buckle stopper. If the angle is
not correct, the sheet does not hit at a right angle to
the stopper, and the folding is skewed.
See page 88 for details.
Move the sheet to the conveyor
using the Normal Jog button.
When doing knife folding, move the sheet to the
fold knife using the Normal Jog button. Continue
pressing the Normal Jog button and press the One
Cycle button for the knife to deliver the sheet.
If the sheet stops between the perforation /
scoring section and the knife fold section
-See page 90, and increase the pressure of
the hold-down roller shown in the illustration.
If the sheet is scratched or smeared by the
steel balls
-See page 90, and decrease the pressure of
the hold-down roller shown in the illustration.
Adjust the register guide angle,
repeating step 4 in section 4-2.
23051
40301A1
If the rear edge of the sheet touches the stopper first,
turn the register guide angle adjusting knob counter-
clockwise so that the angle changes in the direction
shown by the arrow.
Register Guide Angle
Adjusting Knob
First Buckle Stopper
Rear
Front
Handwheel
23051
40301B1
23051
40301C1
13071
40301E1
59