Horizon Fitness AFC-566F Manual page 143

7-7 Installing the Perforation Blade
Replace the blades.
1. Remove the upper blades and holders from the
perforation shaft.
2. Install new blades and holders on the perfora-
tion shaft.
- Tighten the screws while holding the shaft so
that it cannot turn.
- Do not tighten the locking screws on the holders
yet.
- Install each blade with the correct orientation.
- Install each holder in the position shown in
the drawing to the right.
- Decide the perforation blade position by feed-
ing sheets. See Chapter 4, "Fine-Tuning
Adjustments."
Blade Holder A
Locking Screw for
Upper Blade Holder
Upper Blade
Drive Roller
Set the upper blade so that
Lower Blade
the upper blade comes to
outside of the lower blade.
Blade Holder B
3 mm
Perforation
Shaft
Upper Blade
Lower Blade
133