Problems In The Register Guide Section; Sheet Does Not Move Up Against The Register Guide, Or Hits The Register Guide Too Hard; Large Size Sheets Are Not Fed Straight - Horizon Fitness AFC-566F Manual

6-4

Problems in the Register Guide Section

6-4-1 Sheet does not move up against the register guide, or hits the register guide too
hard
Check
The transport
balls are set
incorrectly.
The table posi-
tion is set incor-
rectly.
The positions of
the sheet hold-
down bars and
the air guide are
set incorrectly.
The sheets are
sticky or the sepa-
ration air pressure
is too weak.

6-4-2 Large size sheets are not fed straight

Check
The feed scale
pin is pushing
against the edge
of the stack.
106
Cause and Recovery
- If the sheet hits the register guide too hard,
reduce the number of steel balls or replace
them with plastic ones.
- If the sheet does not move up against the
register guide, increase the number of steel
balls.
23051
60401A1
- Check that the feed scale pin just touches
the stack. If necessary, adjust the position of
the table by turning the feed table wheel.
23051
60401B1
- Adjust the positions of the sheet hold-down
bars depending on the sheet type.
- Adjust the position of the air guide depend-
ing on the sheet width.
23051
60401C1
- Fan the sheets correctly and/or increase the
separation air pressure.
0 0
MAX
23051
60401D1
Cause and Recovery
- Adjust the position of the table by turning the
feed table wheel so that there is a space of 2
to 3 mm (0.08" to 0.12") between the feed
scale pin and the stack.
23051
60402A1
Page
page 50
page 45
page 45
page 48
Page
page 45