Adjusting Fold Skew On Buckle Chute Below Knife - Horizon Fitness AFC-566F Manual

4-9

Adjusting Fold Skew on Buckle Chute below Knife

If skewed folding occurs in the buckle chute below the
knife, adjust the following items. If folding line is
shifted parallel, refer to section 4-10.
1. Check the roller gap below knife
2. Adjust the angle of the knife
3. Adjust the angle of the buckle stopper below knife
1. Check the roller gap below knife
Check which side of the sheet being
folded is skewed.
If the folding is skewed as shown in
the drawing, increase the 9th, 10th
roller gap on the right side, or make
the gap smaller on the left side.
Setup - Roller Gap Fine - Tune Screen
10
Left Side
23051
40901F1
If the folding is skewed as shown in
the drawing, increase the 9th, 10th
and 11th roller gaps on the left side,
or make the gaps smaller on the
right side.
Setup - Roller Gap Fine - Tune Screen
10
Left Side
23051
40901F1
Normally, the roller gaps should be the same on
each side. If the gaps are uneven, this can cause the
sheet to wrinkle, and the fold line will not run straight.
Even if the roller gaps are set the same on each
side, the folded side of the sheet may be delayed.
This depends on the sheet material, the sheet thick-
ness, and the sheet grain. If this happens, reduce
the roller gap on the folded side a little.
Right Side
Right Side
Left Side
Right Side
Right Side
Left Side
9th Roller
10th Roller
11th Roller
The roller pressure is too strong.
(The roller gap is too narrow.)
Transport Direction
23051
40901A1
9th Roller
10th Roller
11th Roller
Transport Direction
The roller pressure is too strong.
(The roller gap is too narrow.)
23051
40901B1
77