Horizon Fitness AFC-566F Manual page 108

6-1 If an Error Icon Appears on the Screen
First, press the Emergency Stop button and remove all the jammed sheets.
Then, perform the following procedure:
Jam Error Screen
?
2 3 1
Description
Jam Code 231 : Sheet jam is detected by the sheet pass
sensor. Or, double feed is detected by the
double feed sensor while the motor is running.
When the machine is connected to RFU-54,
sheet jam is detected by the rotor section
sheet pass sensor or the gate section sheet
pass sensor on RFU-54. Or, double feed is
detected by the double feed sensor on
RFU-54 while the motor is running.
Jam Code 234 :
Sheet jam is detected by the double feed
sensor.
When the machine is connected to RFU-54,
sheet jam is detected by the double feed
sensor on RFU-54.
?
2 3 2
Description
The sheet pass sensor is blocked when it
Jam Code 232:
should not be.
When the machine is connected to RFU-54,
the rotor section sheet pass sensor or the
gate section sheet pass sensor on RFU-54
is blocked when it should not be.
?
1 3 1
Description
Jam Code 131:The knife timing sensor remains
On more than the allowable time.
98
If you leave any sheets in the machine, the machine may jam again, or the machine may
be damaged.
1.Adjust the sheet edge guide at the sheet edge.
2.Check that the position of the feed scale pin is
correct.
3.Check that the position of the register guide is
1.Reduce the feed rotor suction length.
2.Adjust the suction point of the feed rotor.
Set the transport rollers so that the sheet is trans-
ported smoothly.
Recovery
correct.
Page
50
45
69
83
84
53