Adjusting Fold Skew In Parallel Folding - Horizon Fitness AFC-566F Manual

4-4

Adjusting Fold Skew in Parallel Folding

Normally you can correct skewed folding by adjusting
the angle of the register guide. If the skewed folding
cannot be corrected by adjusting the angle, perform
the following items.
1. Check the buckle chute setting
2. Adjust the roller gap
3. Adjust the angle of the buckle stopper
- In normal operation, set the roller gaps on
each side evenly. If the gaps are not even,
this can cause the sheet to wrinkle, and the
scoring or perforation line will not run straight.
- Only the first folding can be corrected by
adjusting the register guide angle. To correct
the second folding or others, adjust the roller
gap and the buckle stopper angle.
1. Check the buckle chute setting.
Set the buckle so that the bolt on the buckle support
hits the bracket without any gap.
2. Adjust the roller gap.
Check which side of the sheet being
parallel folded is skewed.
If the folding is skewed as shown to
the right, adjust the gaps this way:
(1) Make the first gap on the rear wider, or make
the first gap on the front narrower.
(2) Make the second gap on the rear narrower, or
make the second gap on the front wider.
The accuracy of the parallel folding may
improve as the machine runs.
60
Skewed Folding
Buckle Chute Support
Bolt
Bracket
8 6
1
3
5
Rear Side
Front Side
23051
40401A1
23051
40201F1
4 2 1 3 5
2
4
6
23051
40401B1
7