Horizon Fitness AFC-566F Manual page 83

4-7 Setting the Perforation Blades and Scoring Blades
Setup for optional center cut blade
(1) Remove the perforation shaft. Refer to section
7-5.
(2) Attach the center cut blade to the perforation
shaft, then install the perforation shaft to the
machine.
(3) Adjust the slit width by changing the spacers
between the blades.
(4) Adjust the upper blade positions to create the
correct slit.
(5) Align the lower blades to the upper blades and
lock them with the set screws.
(6) Install the upper and lower trim guides on the
support bar. (There are two types of trim
guides: 2 mm thickness and 5 mm thickness )
- Each upper blade is made in two halves.
The position of the upper blade can be
changed by loosening the holder and mov-
ing the spacers.
- Before installing a new set of upper blades,
make sure the two halves fit together cor-
rectly.
- The slit width is the total of the thickness of
the spacers plus 1.6 mm (0.063") for the two
upper blades (0.8 mm or 0.031" each).
Set the drive rollers.
- If the perforation line is within 12 mm (0.47") of
the sheet edge, stabilize the sheet by holding
the sheet edge with a drive roller, so that the
perforation line will run straight.
- Attach the driver rollers evenly from the perfora-
tion blade.
If doing perforating in the center of the sheet,
set the drive rollers so that the sheets move
smoothly.
Spacers
1 mm thickness (1 pc)
2 mm thickness (3 pcs)
3 mm thickness (2 pcs)
Upper
Installed in this order:
Blade
1, 3, 2, 2, 3, 2 mm.
Upper
Trim Guide
Screw
Lower
Blade
Lower Trim Guide
23051
40701G1
When doing perforating
23051
40701H1
Upper Blade
Holder
Drive Roller
13071
40701I1
73