The Folds Are Not Square To The Edges Of The Sheet - Horizon Fitness AFC-566F Manual

6-5 Problems in the Buckle Chute Section

6-5-2 The folds are not square to the edges of the sheet

Check
The sheet does
not reach the reg-
ister guide, or the
sheet hits the reg-
ister guide too
hard.
The register guide
angle is incorrect.
The gap between
the fold rollers is
uneven.
A buckle chute is
installed incor-
rectly.
The sheets are
curled, or the
grain direction is
not parallel to the
fold roller.
The sheets are
not trimmed at
right angles.
The fold rollers
are dirty.
108
Cause and Recovery
- If the sheet does not reach the register
guide, increase the number of steel balls.
- If the sheet hits the register guide too hard,
reduce the number of steel balls or replace
them with plastic ones.
23051
60401A1
- Adjust the register guide angle.
23051
60502A1
- Set the fold roller gap correctly so that it is
even at both ends.
23051
60502B1
- Reinstall the buckle chute.
23051
60502C1
- Adjust the register guide angle.
- If the sheet is still not folded correctly, adjust
the roller gap.
23051
60502D1
- Adjust the buckle chute stopper angle.
23051
60502D1
- Clean the fold rollers.
23051
60502F1
Page
page 50
page 59
page 61
page 130
page 59,61
page 88
page 126