Horizon Fitness AFC-566F Manual page 52

3-3 Setting the Positions of the Guides and Buckle Chutes
Press OK on Check/Instruction
Screen 1.
- All the roller gaps are set at once.
- All the guides and buckle chutes move. Check/
Instruction Screen 2 appears after the auto-
matic setup is finished.
- If the cover is opened during changeover, the
machine stops immediately. In that case, close
the cover and press
Buckle screen to perform the changeover again.
(1)If you are not using knife folding, remove the
knife stopper. If you are using knife folding, set
the knife stopper.
(2)Install the side guides for small sheets if the
sheet width is less than 95 mm (3.8"). Remove
the side guides for small sheet if the sheet
width is 95 mm (3.8") or more.
(3) Install the sheet guides in the knife fold section.
(4) If a mechanism fails to reach to the home posi-
tion, the Error Screen appears. Use the error
code to tell which mechanism did not reach the
correct setting. Fins out why the part could not
move to the correct position.
Error Screen
Press OK on Check/Instruction
Screen 2.
- The Roller Gap screen appears.
42
on the Guide-
Error Code
23051
30301G1
Side Guide For
Small Sheets
Sheet Guides in the Knife Fold Section
Check/ Instruction
Screen 2
OK
Knife Stopper
23051
30301E1
23051
30301F1
Roller Gap Screen
23051
30301H1