Setting The Register Guide - Horizon Fitness AFC-566F Manual

3-6

Setting the Register Guide

Set the sheet edge guide.
- Set the guide to match the far edge of the sheet.
The sheet edge guide prevents the edge of a
sheet from catching on the gap of the side lay
table.The smaller the area where the sheet
edge guide covers a sheet, the less interfer-
ence there is with the sheet transfer.
Set the sheet holders.
- Set the sheet holders to match the sheet width.
These are especially important for light sheets.
Use of these holders depends on the stiffness
of the sheet.
Set the transport balls.
-Arrange the steel and plastic balls to control the sheet
smoothly. See the drawing to the right. When the top of the
sheet is touching the stopper in the first buckle chute, place
plastic balls near the bottom of the sheet.
If the sheet is large or heavy, replace these with steel balls.
-If the sheets rise too close to the register guides,
reduce the number of steel balls or replace them with
the plastic balls. If the sheets do not rise far enough,
increase the number of transport balls.
If the sheets are caught in the ball holes, insert the
plastic balls. See the following section, "Setting the
Register Guide."
50
Sheet Edge Guide
Sheet Holder
1
Buckle Stopper
3
5
2
4
23051
30601A1
23051
30601B1
Ball
End of Sheet
23051
30601C1