Setting The Suction Head - Horizon Fitness AFC-566F Manual

3-5

Setting the Suction Head

Set the separator.
- Adjust the separator so that the grip area is
about 4 mm (about 0.16").
Adjust the separator using the grip area width
adjusting knob and the sheet hold angle
adjusting knob.
If double feeding occurs frequently,
increase the grip area (direction shown by
arrow 1) or loosen the locking screw first,
then increase the separator angle (direction
shown by arrow 2). For thin sheets, reduce
the sheet hold angle.
Set the height of the vacuum piston.
- In normal use, adjust the vacuum piston using
the suction cup height adjusting knob so that
the gap between the sheets and the vacuum
piston is about 1 mm (0.04").
- To reduce the gap, turn the knob clockwise.
If the vacuum piston feeds two sheets
because the sheets are porous, raise the vac-
uum piston.If the vacuum piston fails to feed a
sheet because the sheet is heavy, lower the
vacuum piston.
46
(1):Grip Area Width Adjusting
Knob
(2):Sheet Hold Angle Adjust-
ing Knob
Locking Screw
1
2
Suction Cup Height
Adjusting Knob
Vacuum Piston
2
1
4m m
Separator
23051
30501A1
Vacuum Piston
Down
23051
30501B1