Properties Screen - Horizon Fitness AFC-566F Manual

1-2 Touch Panel Description

1-2-13 Properties Screen

This screen displays information about this machine: date setting, machine operating history, serial
number, and software version. This screen also has buttons that go to other screens. The Monitor
screen shows the input signals from the sensors. The Job Record screen and Error Record screen
report on the operation of the machine.
Double Feed Detect Photoelectronic Sensor
This value is displayed only when photoelectronic sensor
is selected. When light amoutn is set to
the sensor is OK if value in the r a nge between 140 and
145 is displayed here .
If the value out of the r a nge is displayed, clean the sensor.
T otal Run Time
The total run time of the machine (in hours)
appears here .
Time Setting
This indicates the current time . The time can be reset.
Date Setting
This indicates the current data. The data can be
reset.
Press this area, and the Numeric Keypad screen
appears. Input the date using the Numeric Keypad
screen.
Serial Number
The serial number of this
machine appears here.
T otal F eeding Counts
The total n umber of the
sheets run through the
machine appears here.
30
23051
10212A1
This presents the daily machine
operating conditions.
Sensor , Switch Input Monitor
.
Knife Timing Sensor
.
Job Record
This presents a report of any
errors.
Properties Screen
Suction Head
Support Detect Switch
T able Slow-down
Sensor
Double F eed Detect
Ultrasonic Sensor
Feed T able
Sensor
Feed T able Feed Table
Lowering Error
Lower Limit Sheet Loading
Position Sensor
Detect Switch
Switch
This displays the input condition
of the sensor and switch signal.
: ON : OFF
Software Version
The current software versions of various
parts of the machine appear here.
Please report these numbers in case of a
service cal l l.
Administrator Settings
Enter the password to open the
Administrator setting screen.
See page 31.
Service
This goes to the Service screen.
This button should only be used
by service personnel.
Error Record
1-2-13