Horizon Fitness AFC-566F Manual page 71

4-4 Adjusting Fold Skew in Parallel Folding
Adjusting each roller gap
To make a rough adjustment
(adjusting the number of sheets.)
- In this procedure, roller gap on both sides are
adjusted evenly. To adjust the roller gap on
either side only, refer to "In case of the fine -
tune ".
(1) Change the number of sheets on the Setup-
Roller Gap screen.
(2) Press .
Both ends of the roller are adjusted.
In case of the fine - tune
µ
(adjusting by 5 m at minimum.)
(1) Press to display the Roller Gap Fine-
Tune screen.
(2) Select the roller gap to be adjusted.
- Touch the desired roller on the screen or press
or buttons to select the roller gap.
- The selected roller is displayed in blue.
(3) Change the gaps.
µ
: Increase by 5 m
µ
: Decrease by 5
After you press the
gaps are actually adjusted a few seconds
later.
: Adjusting one side only
: Adjusting both sides at once
m
or buttons, the
Setup - Roller Gap Screen
For Fine - Tuning
Setup - Roller Gap Fine - Tune Screen
1
80
+5
Gap
Micro
Adjusting
Button
23051
Both/One Side Select Button
40401C1
1
80
80
-5
Gap Micro
Adjusting
Button
61