Main - Condition Screen - Horizon Fitness AFC-566F Manual

1-2 Touch Panel Description

1-2-3 Main - Condition Screen

Feed Rotor Suction Length
D
When (default) is pressed,
the suction length is set to 3/10
of the sheet length.
Belt Speed
This sets the speed of the fold roller and transport belt.
Max. 240 meters per minute (The maximum speed depends on the fold pattern.)
Min. 30 meters per minute
Feed Interval
:The value from 10 to 999
(0.5" to 39.3") can be input.
:Thevalue from 10 to 2,300
(0.5"to 90.5") can be input.
The minumum value is shorter length
by 50 mm (1.97") than the sheet length.
D
When (default) is pressed, the
interval is set to match the delay time
of the knife. Initially, select
If you want to shorten the feed interval
a lot, select
However, this may result in uneven
feeding if the sheets are slippery.
Conveyor Running Time
Continuous (Conveyor runs along with main motor):
Set how long the delivery conveyor (LCV-54)
is running after the main motor stops.
Intermittent (Conveyor runs along with
sheet delivery): Set how long the delivery
conveyor is running after the sheet is
delivered. (When the motor starts moving,
conveyor does not start moving at same timing.)
20
Knife Delay Time
The feed interval is automatically made longer when the
knife delay time is increased.The taller the level bars
on the display, the longer the knife delay time.
When the delay time is set to the minimum, the knife
lowers at the moment when the sheet hits the knife stopper.
If the belt speed is drastically changed,
the folding quality may deteriorate. Do a
test feed to check the folding quality
before running the machine.
Double (Multiple) Feed Detection
/
: Not Used
Ultrasonic Detection : Double feeding is detected by the
ultrasonis sensor. Two-part form cannot be detected correctly
by this sensor. In that case, use the photoelectronic sensor.
.
Photoelectronic Detection: Double feeding is detected by the
photoelectronic sensor. According to the printed condition
.
(paint or color), this sensor may misdetect the double
feeding. In that case, use the ultrasonic sensor.
Icons below are display only when photoelectronic detection is selected.
You can change these settings
while the machine is running.
/
: Set the brightness of the double feed detecting
/
lamp. When detecting thick sheets (100 gsm
or thicker) or sheets with lots of dark printing,
use the brighter setting.
: Set the sensitivity of the double feed detection.
The bigger the level bar is, the higher the sensitivity.
- If the sensor misdetects the correct feeding as
double, decrease the sensitivity.
- If double feeding is not detected and passes through,
increase the sensitivity.
1-2-3
Condition Screen
.
.
23051
10203A1