Gap Adjustments Between The Buckle Chutes And Fold Rollers - Horizon Fitness AFC-566F Manual

4-12 Other Adjustments

4-12-4 Gap adjustments between the buckle chutes and fold rollers

-Normally it is not necessary to adjust the gap
between the buckle chute and the fold roller. If the
fold does not appear at the correct point, identify the
affected buckle chute and change the clearance.
-Change the gap by adjusting the lengths of the bolts
on the buckle chute supports.
CAUTION
The gap can be reduced by turning the bolt in.
Allow a minimum gap between the lock nut
and bolt of 1 mm (0.04") to prevent the buckle
chute and roller from hitting.
-When the adjustment is complete, tighten the lock
nut.
CAUTION
-Make the same adjustment on each side.
-If the gap between the buckle chute and fold
roller is set too narrow, and the buckle chute is not
set correctly, the end of the buckle chute may hit
the roller, and this can damage the roller.
Buckle Chute Support
Lock Nut
More than 1mm
(0.04")
Bolt
23051
41204A1
87