Suction Head Section 1 - Horizon Fitness AFC-566F Manual

1-1 Machine Description

1-1-4 Suction Head Section 1

The suction head section adjusts position automatically during changeover to match the sheet length.
Sheet Hold-down Weights
These weights help to control the sheet.
Attach or remove weights to match the
type of sheet.
Set Register Pin Locking Knob
Suction Piston Height Adjusting
Knob
This knob is used to adjust the
space between the suction cup
and the top of the stack.The
standard space is about 1mm
(0.04").
Sheet Hold-down Pres-
sure Adjusting Knob
This knob adjusts the pressure
produced by the sheet hold-
down bar against the sheet.
The higher the setting on this
knob, the greater the hold-
down pressure.
Sheet Hold-down Bar
This holds down the rear
edge of the stack.
Set Register Pin
Fit the pin against the back of the stack.
4
Blower Air Nozzle
The blower air exits.
Air Guide
This guide holds the sheet lightly
and prevents the separation air from
leaking out to the sides.
Suction Head Section 1
Suction Head Stop Switch
When the vacuum piston picks up the
sheets which width is narrow, the suction
head can rise a little, and the gap between
the vacuum piston and sheets can widen.
In this case, turn off this switch so as not to
move the vacuum piston.
When lowering the feed table, the suc-
tion head raises even if this switch is
turned off. And when raising the feed
table with this switch turned off, the suc-
tion head does not lower and cannot
catch the sheet. Be sure to turn this
switch on before raising the feed table.
Blower Air Position Adjusting
Knob
This knob is used to adjust the height of
the blower air nozzles.
Blower Air Pressure Adjusting
Knob
Separation Air Pressure
Grip Area Adjusting Knob
Turn the knob clockwise to move the
grip area forward.
Sheet Hold Angle Adjusting
Knob
Turn the knob clockwise to increase the
angle.
Air Guide
1-1-4
23051
10104A1