Removing And Installing The Perforation Shaft - Horizon Fitness AFC-566F Manual

7-5

Removing and Installing the Perforation Shaft

In order to replace the scoring rollers, blade holders, and drive roller you have to remove the perforation shaft.
Turn off the power switch.
If the perforation blades are installed,
slide the upper blade holder to separate
the upper blades from the lower blades.
- This prevents the upper blades from hitting the
lower blades and being damaged when the per-
foration shaft is removed.
132
Lower the perforation shaft lifting lever.
The upper perforation shaft rises. This will sepa-
rate the upper scoring wheels from the lower
blades.
Loosen the set screw of the shaft
holder on the operator side.
- Use a 3 mm hex driver.
Push in the shaft holder on the oper-
ator side.
Remove the perforation shaft.
- Pull the perforation shaft to the operator side to
remove the pin from the groove, and lift the
entire perforation shaft.
Install the perforation shaft in the
reverse order of removal.
When installing the shaft,
insert it until it stops.
Bearing
3 mm Hex Driver
Pin
Shaft
Holder
Locking Screw
WARNING
Do not touch the blades. Otherwise, a sharp
blade can cause severe personal injury.
CAUTION
Make sure to move any blades away from the
lower blade. Otherwise, the blades may be
damaged.
- When you install the perforation shaft, insert
the rear end so that the cutout fits completely
over the pin.
- After you install the shaft holder, make sure to
check that the bearing on the front is com-
pletely inserted to the shaft holder and check
that the perforation shaft does not move.
The bearing can
Check Point
not be seen.
The shaft
does not
move.
13071
70501A1
129