Horizon Fitness AFC-566F Manual page 73

4-4 Adjusting Fold Skew in Parallel Folding
Try the parallel folding again and
check the folding accuracy.
- If the skewed folding still occurs, check the
roller pressure on the front and rear rollers in
the following procedures.
WARNING
Before checking the roller gaps, stop the
machine completely.
(1) Reset the "Zero" point of the roller gap.
- Press the Thickness Zero Point Adjusting but-
ton on Roller Gap Fine-Tune screen without
inserting a sheet into the gap adjusting lever.
"Zero" point will be saved.
(2) Insert one sheet of paper (52.2 gsm or 14 lb
bond) into the gap adjusting lever.
(3) Press the Thickness Measuring button on the
Roller Gap Fine-Tune screen.
(4) On the Roller Gap Fine-Tune screen, change
the number of sheet to "1" on each roller.
(5) Press .
- All roller gap are set for one sheet.
(6) Remove the sheet holders in the register guide
section.
(7) Take the same type of paper you will run, and
tear it into strips. Insert one strip into the roller
gap.
(8) Adjust the roller gap on the screen so that the
rollers turn slowly when you pull out the strip.
(9) Adjust the roller gap on both sides by the same
amount.
Thickness Zero Point Adjusting button
Thickness Measuring button
Setup - Roller Gap Fine
- Tune Screen
Setup - Roller Gap Screen
1 1 1
1
1
1
1
One Sheet of Paper
(52.2 gsm or 14 lb bond)
Handwheel
When checking the other roller gaps, remove
the buckle chute. Insert strips of paper as
shown below, and check the roller gaps.
1
3
2
5
4
3
6
5
8
4
7
6
23051
40401F1
1 1
1
1
1
13071
40401H1
Sheet Holder
23051
40401E1
1
2
63