Removing The Buckle Chute - Horizon Fitness AFC-566F Manual

7-6

Removing the Buckle Chute

Remove the buckle chute if a sheet jam occurs in the
buckle chute, or if you want to replace it with the
optional gate fold buckle chute.
First, Third and Fifth Buckle Chutes
Disconnect the buckle chute cable
connector.
Loosen the locking levers.
- There are locking levers on the operator side
and the rear.
Remove the buckle chute.
- Pull out the buckle chute by lifting it up
through the guides.
Second, Fourth and Sixth Buckle Chutes
Disconnect the buckle chute cable
connector.
Check that the buckle chute stop
wire is attached.
- There are wires on the front and rear.
Loosen the locking lever.
The buckle chute will slide down and be
stopped by the wire.
Remove the wire.
- Lift the buckle chute a little and unhook the wire.
Remove the buckle chute.
130
WARNING
Turn off the power switch before removing the
buckle chute. Otherwise, a sudden start can
cause severe personal injury.
Loosen
Locking Lever
23051
70601B1
Buckle Chute Cable
Connector
23051
70601A1
Loosen
Stop Wire