Panasonic FP-XH M8N16PD User Manual page 494

Specifications
Offset
Name
Address
H10-H11 System reserved
Auxiliary output
H12
mode
Auxiliary output
H13
Delay ratio
AMP operation
H14
setting
26-38
Default Setting range and description
－ －
Sets to enable/disable auxiliary output contacts and auxiliary output
codes. The ON time of auxiliary output contacts is determined by the
following auxiliary output ON time.
bit Name
HA00
Auxiliary output
7-0
mode
Auxiliary output
15-8
ON time
Sets the ratio of output in the Delay mode during auxiliary output. The
K0 setting range is 0 (%)
executed when the position control movement exceeds 50%.
Sets to enable/disable the limit input of AMP, or sets the movement
direction and limit connection method, etc.
Note) This setting should be written to the EEPROM within the AMP,
and the AMP should be restarted after changing the setting.
bit Name
0
Limit
enabled/disabled
H1
1
CW/CCW moving
direction
2 Limit connection
15～3
－
Default Description
0000H: Disable auxiliary output
function (auxiliary output
contacts and auxiliary
H0
output codes).
0001H: Use With mode
0002H: Use Delay mode
Setting range: 00H (0 ms) - FFH
HA
(255 ms)
100 (%), if set to 50%, the auxiliary output will be
-
Default Description
0 0: Uses the input of limit signal.
1: Ignores the input of limit signal.
0 0: CW+/CCW-
1: CCW+/CW-
0 0: Standard connection (Forward:
CWL, Reverse: CCWL)
1: Reverse connection (Forward:
CWL, Reverse: CCWL)
－ －