Transfer Of Parameters; Download By Fpwn Gr7 - Panasonic FP-XH M8N16PD User Manual

Transfer to Unit and
Commissioning

10.2 Transfer of parameters

10.2.1 Download by FPWN GR7

• Information on parameters that have been set is transferred as part of project information to
the control unit along with programs and system registers. The following steps are performed
with the Configurator PM7 that has been started as a premise.
PROCEDURE
1. Select "File"→"Exit" from the Configurator PM7 menu bar.
2. "Setting data will be applied. Are you sure you want to proceed?" After a
message appears, click [Yes (Y)].
The parameters set on the Configurator PM7 are applied to the project being
edited, and the screen returns to the base screen of the FPWIN GR7.
3. Select "Online"→"Download to PLC" (Entire Project) from the menu bar.
A confirmation message dialog box is displayed.
4. Press the [Yes] button.
Downloading the project is executed. A message dialog box to confirm whether to
switch the mode or not is displayed.
5. Press the [Yes] or [No] button.
Press [Yes] to change to the RUN mode. [Press [No] to continue the PROG.
mode. When changing the RUN mode, the configuration information is valid in the
unit, and the test run using I/O signals or the Configurator PM7 can be performed.
6. Select "Options"→"Positioning Table Settings" from the menu bar.
Configurator PM7 is started. Select [Online]→[Data Monitor], [Status Display],
[Tool Operation] to enter the status available to execute different menus of the
unit.
10-4