Table of Contents
Advertisement
10.2.2 Download by Configurator PM7
In the case of FP-XH M8N Control Unit, parameters and information data can be downloaded
or uploaded on the Configurator PM7. The following procedure is explained on the condition
that the Configurator PM7 has already started.
PROCEDURE
1. Select "File" > "Write PLC" from the menu bar of the Configurator PM7.
A confirmation message box is displayed.
2. Press the [Yes] button.
The positioning parameters are downloaded to the control unit. A message dialog
box to confirm whether to switch the mode or not is displayed.
3. Press the [Yes] or [No] button.
Press [Yes] to change to the RUN mode. Press [No] to continue the PROG. mode.
When changing the RUN mode, the configuration information is valid in the unit,
and the test run using I/O signals or the Configurator PM7 can be performed.
4. Select "Options" > Positioning Table Settings" in the menu bar.
The Configurator PM7 is activated. Select [Online] > [Data monitor] > [Status
display] > [Tool operation] so that each menu items of the unit will be available.
KEY POINTS
When the download is performed on the Configurator PM7, the positioning
•
parameters saved in the F-ROM of the control unit will also be overwritten.
Save the projects as files as necessary.
10.2 Transfer of parameters
10-5
Advertisement
Table of Contents
