Table of Contents
Advertisement
Automatic Operation (Synchronous Control)
Editing of the cam table
Edit the cam table data that was created.
Set the following items for each section set:
• Starting phase (%)
• Displacement (%)
• Cam curve
The cam curve changes according to the settings.
KEY POINTS
•
The termination phase cannot be set. The termination phase will be
changed automatically if the staring phase is changed.
•
Do not make a radical displacement change of set cam curves. There is a
possibility that the motor cannot keep up with the output in the case of
rapid displacement.
•
Similarly, make settings that a phase of 0% and that of 100% are the same in
displacement.
12-28
Advertisement
Table of Contents
