Table of Contents
Advertisement
Auxiliary Function
17.7.2 Setting Procedures and Operations
Setting procedures and operations of movement amount change function
The movement amount change function is activated by the following procedure during a
positioning operation.
1. Set "Change movement amount" in the positioning memory.
2. Turn on the "Movement amount change request" contact during a positioning operation.
* "Movement amount change done annunciation" turns ON when the movement amount
change is actually started.
* Once the "Speed change request" contact turns OFF, the "Speed change done
annunciation" also turns OFF.
Change movement amount
Movement amount change request
Positioning movement amount
change done annunciation
Setting parameters
The following parameters are used in the movement amount change function.
Positioning operation change setting area (Positioning memory area No.3)
Offset
Name
address
(Hex)
Positioning
movement amount
change
HA-HB
Change movement
amount
17-18
f
Positioning movement amount
(Before change)
100,000pls
150,000pls
Initial
Description
value
Area for setting a change movement amount for changing
the positioning movement amount.
H0
-2,147,482,624 to 2,147,482,624 (Specified unit system)
t
Advertisement
Table of Contents
