Ip Igmp Filter (Interface Configuration) - Edge-Core ECS2100-10T Reference Manual

ip igmp filter
(Interface Configuration)
Command Mode
IGMP Profile Configuration
Command Usage
Enter this command multiple times to specify more than one multicast address or
address range for a profile.
Example
Console(config)#ip igmp profile 19
Console(config-igmp-profile)#range 239.1.1.1
Console(config-igmp-profile)#range 239.2.3.1 239.2.3.100
Console(config-igmp-profile)#
This command assigns an IGMP filtering profile to an interface on the switch. Use
the no form to remove a profile from an interface.
Syntax
[no] ip igmp filter profile-number
profile-number - An IGMP filter profile number. (Range: 1-4294967295)
Default Setting
None
Command Mode
Interface Configuration
Command Usage
◆
The IGMP filtering profile must first be created with the
command before being able to assign it to an interface.
◆
Only one profile can be assigned to an interface.
◆
A profile can also be assigned to a trunk interface. When ports are configured as
trunk members, the trunk uses the filtering profile assigned to the first port
member in the trunk.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#ip igmp filter 19
Console(config-if)#
Chapter 23
– 573 –
| Multicast Filtering Commands
IGMP Filtering and Throttling
ip igmp profile