Table of Contents
Advertisement
MSD-701UHD / 702UHD / 801UHD/ 802UHD User's Guide
9.11 RS-232C
The RS-232C connector of the MSD can output communication command control from PCs and can output
control command to external devices from the MSD. The operation mode will be switched according to "9.11.2
RS-232C operation mode".
RS-232C cable
Projector
9.11.1
RS-232C communication setting
Menu
Top→COM PORT→PARAMETERS
Setting for
RS-232C connector, OUT1B connector, OUT2B connector, IN8 connector
Setting value [Table 9.17] RS-232C setting items
Setting item
Baud rate [bps]
Data bit length [bit]
Parity check
Stop bit [bit]
You can set RS-232C communication.
The setting of this menu is not updated until the MENU/SET key is pressed. Make sure to press the
MENU/SET key to update the setting.
90
Twisted pair cable
Twisted pair cable
receiver
Outputting control commands to external devices
Not connected (RS-232C connector operates normally)
[Fig. 9.21] RS-232C communication
[Table 9.17] RS-232C setting items
4800, 9600, 19200, 38400
8, 7
NONE, EVEN, ODD
1, 2
【See: 9.13 Setting control command】
Communication command control to MSD
IN8
RS-232C transmission setting between control
devices (OUT B SCI CONNECT)
Setting value
Laptop
RS-232C cable
Outputting control commands to
external devices
Power amp.
Default
9600
8
NONE
1
Advertisement
Table of Contents
