Table of Contents
Advertisement
MSD-701UHD / 702UHD / 801UHD/ 802UHD User's Guide
9.8.9 The number of HDCP retries
Menu
Top→OUTPUT SETTING→HDCP ERROR RETRY
Setting for
Each output channel (OUTA / OUTB)
Setting value ETERNITY: retry until succeeded [Default]
0 to 100: 0 to 100times
You can set the number of HDCP retries.
If a sink device with HDCP is connected and you set "9.8.7 HDCP" to "HDCP 2.2", "HDCP 1.4", or "HDCP
INPUT ONLY", HDCP is authorized regardless of the status of input signal. Normally, set this menu to
"ETERNITY" to retry the authentication automatically after the first authentication fails. However, you can set
the number of retries manually. (If retry is not succeeded even after the MSD retries for the set number of retry
times, video and audio with HDCP are not output.)
The setting of this menu is not updated until the MENU/SET key is pressed. Make sure to press the
MENU/SET key to update the setting.
9.8.10
Deep Color
Menu
Top→OUTPUT SETTING→DEEP COLOR OUTPUT
Setting for
Each output channel (OUTA / OUTB)
Setting value 24-BIT COLOR [Default], 30-BIT COLOR
You can select the color depth of HDMI signal.
"30-BIT COLOR": signals are output with "30-BIT COLOR" only if a sink device supporting Deep Color is
connected. If a sink device that does not support Deep Color is connected, signals are output with "24-BIT
COLOR" automatically. However, since the transmission clock of "30-BIT COLOR" is faster than that of
"24-BIT COLOR", noise may occur if a bad-quality cable or long cable is connected. In those cases, the noise
may be removed by selecting"24-BIT COLOR".
When the MSD outputs at WQHD (2560 x 1440) / WQXGA (2560x1600) / 4K (3840 x 2160) / 4K (4096 x
2160), the color depth is "24-BIT COLOR".
72
Advertisement
Table of Contents
