Table of Contents
Advertisement
9.15.5
Display position
Menu
Top→BITMAP→POSITION
Setting for
Each output channel, each bitmap
Setting value [Fig. 9.31] Position
You can set the display position of the bitmap.
●
9.15.6
Assigning input channel
Menu
Top→BITMAP→CHANNEL ASSIGN
Setting for
Each input channel, each output channel (Common to OUTA and OUTB)
Setting value OFF [Default], ON (BITMAP1 ON to BITMAP4 ON)
A bitmap can be treated as an input video source by assigning the bitmap to any input that is not currently
being used. Set "9.15.2 Outputting bitmap image" to "OFF".
If multiple bitmaps are registered, select the bitmap number to be output.
If you switch a normal image to a bitmap image, it takes longer time to output the image, and you cannot
perform other operations while the bitmap is being written and displayed.
The setting of this menu is not updated until the MENU/SET key is pressed. Make sure to press the
MENU/SET key to update the setting.
9.15.7
Startup bitmap output
Menu
Top→BITMAP→POWER ON BITMAP
Setting for
Each output channel (Common to OUTA and OUTB)
Setting value OFF [Default], ON (BITMAP1 ON to BITMAP4 ON)
You can enable or disable bitmap output at the time of the MSD startup.
MSD-701UHD / 702UHD / 801UHD/ 802UHD User's Guide
●
TOP-LEFT
CENTER
[Default]
●
BOTTOM-LEFT
[Fig. 9.32] Position
●
TOP-RIGHT
●
BOTTOM-RIGHT
117
Advertisement
Table of Contents
